Ironclad SKC5SN-01-XS Cut-Resistant Coated Gloves, Cut Level A5

Ironclad SKC5SN-01-XS Cut-Resistant Gloves

These gloves provide ANSI/ISEA Cut Level A5 protection for hands exposed to sharp edges and materials. They suit workers in manufacturing, assembly, automotive maintenance and general industrial tasks where laceration risk is high. The HPPE knit shell delivers cut resistance while maintaining dexterity for detailed work. Buyers needing needlestick protection beyond Palm Level 1 or chemical permeation resistance should select a different model.

Double-Dipped Nitrile Coating

The 3/4 double-dipped nitrile coating extends grip coverage across the palm and fingers while leaving the back of the hand breathable. A reinforced thumb crotch adds durability at a high-wear point, reducing premature failure during repetitive gripping. The coating enhances wet and oily grip without sacrificing tactile sensitivity. Users requiring full hand immersion or palm-only coating will find this coverage pattern unsuitable.

Verify ANSI Cut Level A5 Matches Your Hazard

Confirm that your safety officer or risk assessment specifies ANSI/ISEA Cut Level A5 for the intended application. The gloves carry no abrasion rating and offer Palm Needlestick Level 1 only, so they do not address puncture or abrasion hazards beyond that level. Sizing runs by letter designation; measure hand circumference against the manufacturer chart before ordering. Workers with latex allergies can use these nitrile-coated gloves without concern.