SXDOOL PCI-E 6Pin to 3 x DC 5.5 x 2.5mm Power Adapter Cord 12V 18AWG 1M
- Case Fan Accessory
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A six-foot UL-listed cord with a NEMA 5-15P plug and a C5 cloverleaf connector rated for 10 A at 125 V
This six-foot AC power cord connects laptops, monitors and other devices that use the three-pin C5 cloverleaf input to a standard North American NEMA 5-15P wall outlet. The 18 AWG cable is rated for 10 amps at 125 volts and carries a UL listing for safety compliance. It serves as a direct replacement for lost or damaged original cords.
The cord is a passive copper conductor with no active components, so it generates no audible noise and adds no measurable heat to the system. Power delivery is limited to the 10 amp, 125 volt rating marked on the cable, matching typical switched-mode power supplies used with portable computers and displays. No fan, pump or semiconductor is present to affect acoustics or thermal load.
The moulded NEMA 5-15P plug and IEC 320 C5 connector provide a secure, keyed fit that resists accidental disconnection during routine handling. At 1.83 metres the length reaches desktop or floor outlets without excessive slack, and the three-conductor 18 AWG construction withstands repeated flexing at the strain reliefs. The design suits stationary workstations and mobile setups alike.
Measured against everything we stock in Jumper & Adapter Power Cords, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | iTEKIRO |
| Product type | Universal |
| Size & build | |
| Overall length | 6' |
Plug the C5 cloverleaf end firmly into the device inlet until it clicks, then insert the NEMA 5-15P plug fully into a 120 V North American outlet; the step often missed is verifying the C5 seats completely so the ground pin makes contact.
Inspect the 18 AWG cable and both connectors periodically for cracks, discoloration or loose pins; replace the cord if the insulation is damaged or the C5 cloverleaf no longer grips the device inlet securely.
The 10 A, 125 V rating on the 18 AWG conductors is the limiting factor; sustained loads near 10 A will cause the cable to warm, so keep the run uncoiled and in open air to stay within safe temperature rise.
More in Jumper & Adapter Power Cords
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?