Johnson Controls Inc P499RCP-101K pressure transducer 0 to 100 PSI

Pressure Transducer 0 to 100 PSI

The Johnson Controls P499RCP-101K measures system pressure from 0 to 100 psi with a 0.5 to 4.5V DC output. It suits technicians maintaining pressure washer equipment who need a direct replacement sensor. The stainless steel housing and IP67 rating allow installation in wet, outdoor environments. Buyers needing a different pressure range or output protocol cannot use this model.

1/4 in SAE 45° Flare Male Connection

The sensor threads into a 1/4 inch SAE 45 degree flare port using its male process connection. A 3-pin Packard connector provides the electrical interface for the three-wire circuit. It requires a 5V DC power source to operate the 0.5 to 4.5V signal output. Systems lacking this specific flare fitting or connector type will need an adapter.

IP67 Rated for -40 to 185 °F Operation

The transducer maintains its +/-1 percent full-scale accuracy across a temperature span of -40 to 185 degrees Fahrenheit. The IP67 sealed stainless steel body resists water ingress during sustained wash-down cycles. Continuous exposure to pressure spikes near the 100 psi limit does not degrade the calibrated output signal. Installations exceeding this temperature or pressure envelope will lose specified accuracy.