KEHIPI 5 PCS JST SM 3PIN V Shape 1 to 2 Connectors 15CM 22AWG Wire

Five-piece JST SM 3-pin splitter kit

This pack supplies five V-shaped 1-to-2 JST SM connectors on 15 cm 22 AWG leads, letting a single three-pin output drive two addressable LED strips or modules. The 5 V–24 V low-voltage rating matches common WS2811, WS2812B, WS2814, SK6812 and FCOB WS2811 IC strips, and the red-green-white wire colours simplify polarity checks before power-up.

Installers extending SPI addressable runs

Builders who need to branch one controller channel into two parallel strips will find the plug-and-play format convenient, while the short 15 cm pigtails keep voltage drop minimal on typical desktop or accent-lighting runs. Users planning longer daisy-chains or higher-current loads should consider that the 22 AWG conductors and unspecified signal integrity over extended lengths may introduce flicker or dimming, so very long runs or high-density matrices are not a good fit.

Ready-to-use pigtails with no soldering

Each connector arrives pre-crimped and insulated, so the only work required is aligning the three conductors and pressing the housings together; the leads can be trimmed shorter if the 15 cm reach is excessive. The package includes exactly five splitter assemblies and no additional controllers, mounting hardware or configuration software, so any SP105E, SP107E, SP108E, SP611E, SP602E, SP530E, SP630E, SP638E or DR03W controller must be sourced separately.