Klein Tools 85191 Conduit Reaming Screwdriver 5/16 tip 13 19 25 mm
- Card
- * Hooded-blade desi…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A set of five coloured silicone test leads with dual IC hook clips for low-current circuit testing
The KEHIPI P1520 set supplies five coloured hook clips on 50 cm silicone leads rated at 20 AWG. Copper alloy hooks give firm contact on dense boards while the soft insulation stays flexible across temperature extremes. Technicians, students and hobbyists use them for IC level checks, phone repair and bench prototyping where space is tight.
Passive copper alloy clips and silicone wire add no active heat or noise to the test bench. The 20 AWG conductors handle the low current signals typical of logic and sensor probing without measurable voltage drop. No fan, pump or power supply is involved so the kit draws zero power and adds no acoustic load to a quiet lab.
Each lead terminates in a standard hook that slips onto multimeter probes, oscilloscope inputs or bare header pins. The 50 cm length reaches across a typical bench while the five colours keep signal, ground and data lines straight. No adapters, drivers or software are required; the clips free up both hands for soldering or firmware work.
Measured against everything we stock in Electrical Trade Tools & Kits, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Goupchn |
| Model name | P1520 |
Push each dual IC hook onto the test point first, then plug the 4 mm banana into the meter; the 50 cm silicone gives enough slack to route away from neighbouring pins.
Replace a lead if the hook tip bends permanently or the silicone shows cracks; both materials withstand repeated low-current use but fatigue after many insertions.
The 20 AWG silicone leads are rated for low-current testing only; sustained loads above a few hundred milliamps will cause noticeable warming.
More in Electrical Trade Tools & Kits
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?