Klein Tools 85191 Conduit Reaming Screwdriver 5/16 tip 13 19 25 mm
- Card
- * Hooded-blade desi…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Five dual-ended alligator clip leads with copper jaws, 15 A and 1500 V rating, 6.56 ft silicone-insulated wire and .39 in maximum jaw opening
The KEHIPI UR-US-HL9OR5 supplies five dual-ended alligator-to-alligator clip leads for electrical testing. Each lead uses soft silicone insulation over copper clips rated at 1500V and 15A. The clips open to a maximum width of .39in for secure attachment. The total wire length measures 74.6in per lead, providing generous reach for remote test points.
Hobbyists, students and technicians assembling temporary circuits or probing automotive accessories will find the colour-coded leads convenient. The insulated boots reduce accidental shorts during hands-free measurements. Builders who need higher current capacity, specialised probe tips or shielded cables for sensitive signal work should look elsewhere.
The 15A rating comfortably handles fused automotive accessory circuits and typical bench power supplies. The 1500V rating covers most low-voltage laboratory and vehicle systems. Leads will run out of headroom on unfused high-current starter circuits or any application exceeding the stated 15A continuous limit.
Measured against everything we stock in Electrical Trade Tools & Kits, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Brand name | Sumnacon |
| Model name | UR-US-HL9OR5 |
Each lead is 6.56 ft (74.6 in) long, so measure the distance between your two furthest test points and ensure it is less than that length.
The clips open to .39 in (1 cm), which fits most vintage motorcycle screw terminals and small-gauge wires.
Place a calibrated ammeter in series with the clip leads; the reading should stay at or below 15 A while the circuit is energised.
More in Electrical Trade Tools & Kits
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?