Knoll Systems LP25 Genuine Compatible Projector Lamp 200W 3000 Hrs
A 200W SHP projector lamp rated for 3,000 hours, supplied as a complete housing for quick installation
- Power rating200 W
- Lamp lifespan3,000 Hrs.
- Product typeSHP
- Ready to install with pre-assembled bulb and housing
- 200W SHP lamp delivers specified brightness
- 3,000-hour rated life supports extended use
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Knoll LP25 Replacement Lamp Module
The Knoll LP25 is a new, fully assembled projector lamp module that combines a genuine 200W SHP bulb with its housing. It is built for owners of compatible Knoll projectors who need a direct, ready-to-fit replacement without sourcing separate components.
200W SHP Bulb With 3000-Hour Rating
The single specification that determines fit is the 200-watt SHP bulb rated for 3000 hours of operation. Projectors designed for a different wattage or lamp type will not accept this module, so verify the original lamp code before ordering.
Pre-Assembled Housing For Straightforward Swap
Because the bulb comes pre-installed in its housing, installation typically requires only opening the projector’s lamp door, removing the old module and sliding the new one into place. The most common issue is forgetting to reset the projector’s lamp-hour counter after fitting, which can leave the replacement warning active.
How it compares
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
- Price $101.99
- Typical for this category: the median of 9,513 items is $99.99.
- Power rating 200 W
- Lower than about 60% of the 8,831 comparable items (median 215 W).
Specifications
| Product | |
|---|---|
| Brand name | Knoll |
| Product type | SHP |
| Display | |
| Lamp lifespan | 3,000 Hrs. |
| Power | |
| Power rating | 200 W |
Questions about this item
How bright will the 200W SHP lamp be in my Knoll projector?
The 200W SHP bulb delivers the rated output Knoll designed the projector around, so image brightness matches the original specification for this model.
Does the LP25 module use a proprietary connector or a standard lamp interface?
It ships as a complete housing with the same mechanical and electrical interface as the factory lamp, so it plugs straight into the projector without adapters.
Will the LP25 housing fit the lamp cage on my Knoll projector?
Yes, the module is built to the same dimensions as the original LP25 assembly, so it seats and locks in the existing lamp compartment.
More in Replacement Projector Bulbs
