LORDWORLD XT60 to DC 5.5x2.1mm Adapter

XT60-to-DC Adapter for TS100 Soldering Iron

This adapter connects a TS100 soldering iron directly to any battery or power source equipped with an XT60 output. It bridges the XT60 male plug to a 5.5 × 2.1 mm DC male barrel jack, letting field technicians power the iron without a mains supply. The moulded housing uses high-temperature-resistant insulation for safe operation during extended soldering sessions. Pilots and hobbyists carrying a portable iron for on-site repairs will find it indispensable.

Replaces Improvised Wiring and Bulky Converters

Instead of soldering custom pigtails or carrying a separate step-down module, this single-piece cable delivers a secure, polarity-correct link in seconds. The jump is worth it whenever you need a reliable, repeatable connection between a 60 A-rated XT60 pack and the iron’s DC input, especially in vibration-prone multicopter or vehicle environments. It eliminates the loose joints and exposed conductors that cause intermittent heating or shorts during critical field work.

Plug-and-Play Installation With Polarity Check

Simply insert the XT60 male into the battery and the 5.5 mm barrel into the TS100; no tools, screws or configuration are required. The angled vertical strain relief reduces cable fatigue at the connector junction. The only common issue is reversing the barrel polarity if the power source is not clearly marked, so verify centre-positive wiring before first use.