LUOM DP8KA1 DisplayPort Cable 10 ft Grey

10 ft DisplayPort 1.4 cable for 8K

This 10 ft DisplayPort 1.4 cable connects a graphics card or laptop to a monitor with male-to-male connectors. It supports 8K at 60 Hz, 4K at 144 Hz and 2K at 240 Hz, making it suitable for high-resolution work and competitive gaming. The cable is rated for 32.4 Gbit/s HBR3 bandwidth and handles HDR, HDCP 2.2, DSC and Forward Error Correction. Solid copper conductors and triple shielding aim to preserve signal quality over the full length.

Bandwidth ceiling and compression at 10 ft

DisplayPort 1.4 tops out at 32.4 Gbit/s, so 8K at 60 Hz and 4K at 144 Hz rely on Display Stream Compression 1.2 to fit within the link. Without DSC the cable would be limited to lower resolutions or refresh rates at this length. The 28 AWG copper construction and triple shielding help maintain the required signal integrity, but the physical link cannot exceed the standard’s maximum data rate. Buyers planning uncompressed 8K above 30 Hz should note the interface constraint.

Check port version and DSC support before ordering

Verify that both your source and display have DisplayPort 1.4 ports and that the graphics driver enables DSC for the target resolution and refresh rate. Older GPUs or monitors limited to DisplayPort 1.2 will fall back to 4K at 60 Hz or lower. Ensure the device outputs the desired mode — 8K at 60 Hz, 4K at 144 Hz or 2K at 240 Hz — over a single DisplayPort 1.4 link. The cable is backward compatible with DisplayPort 1.3, 1.2, 1.1 and 1.0, but higher modes need the full 1.4 feature set.