We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
M.A. Ford CXDCR 1210AP 12.10 mm Cyclone Xd 5X Coolant Fed Double Margin Drill

M.A. Ford

M.A. Ford CXDCR 1210AP 12.10 mm Cyclone Xd 5X Coolant Fed Double Margin Drill

SKU CH-ZN4H-0QFFH

A 12.10 mm Cyclone Xd drill with 5× coolant feed and double margins for precise drilling

  • 10 mm diameter suits precise hole sizing
  • 5X flute design improves chip evacuation speed
  • Coolant-fed channels reduce heat buildup
  • Double margin construction enhances drilling stability
  • M.A. Ford manufacturing ensures professional-grade durability

12.10 mm Cyclone Xd 5X Drill

This 12.10 mm Cyclone Xd 5X coolant-fed double margin drill from M.A. Ford targets professional machinists and maintenance teams who need precise, deep-hole drilling in tough alloys. The specialist geometry supports accurate hole straightness and improved chip evacuation during extended production runs. Buyers who need larger diameters or non-coolant-fed tooling will need a different specification.

Thermals, noise and power draw

The drill body manages heat through internal coolant channels that deliver fluid directly to the cutting zone, reducing thermal buildup at the workpiece interface. Cutting noise and machine power draw depend on the host equipment, spindle speed and material being drilled rather than the tool alone. No standalone acoustic or electrical ratings are published for this cutting tool.

Sustained-load behaviour

Under continuous operation the double margin design maintains hole alignment and surface finish while the coolant feed flushes chips from deep holes. The Cyclone Xd 5X geometry resists deflection during long cuts, helping to preserve dimensional tolerance over repeated cycles. Tool life varies with workpiece hardness, coolant quality and programmed feed rates.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $396.99
Pricier than about 91% of the 2,412 comparable items (median $81.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

How do I install the CXDCR 1210AP 12.10 mm drill and what step is often missed?

Mount the drill in a rigid holder with through-coolant capability, then verify that the coolant passages align before tightening; skipping the alignment check causes premature margin wear.

What maintenance or replacement will the CXDCR 1210AP need during its life?

Inspect the double margins after each job; replace the drill when margin wear reaches the supplier's wear limit or when hole quality drops below tolerance.

What limit appears first on the CXDCR 1210AP during sustained high-feed drilling?

The double-margin design shifts the first limit to margin wear rather than chip evacuation, so monitor margin land width for the earliest sign of failure.

More in Power Drills, Drivers & Cutting Bits

Similar items