We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cyclone Xd 5X solid double margin drill 14.70 mm

M.A. Ford

M.A. Ford CXDSR 1470AP Cyclone Xd 5X Double Margin Drill 14.70 mm

SKU CH-4DN2-WJ1CY

Solid double-margin drill creates precise 14.70 mm holes at five times the standard depth

  • 5X diameter drilling depth reduces cycle time
  • Double margin design improves hole straightness and finish
  • 70 mm diameter suits precise hole requirements
  • Cyclone Xd geometry enhances chip evacuation
  • Solid carbide construction resists wear in tough materials

What it is

This M.A. Ford Cyclone Xd drill is a 14.70 mm solid carbide cutting tool built for 5× diameter hole depths. The double-margin design adds a second land for improved guidance and hole straightness in deep drilling operations. It targets machine shops and maintenance teams that need consistent accuracy without peck cycles.

Sustained-load behaviour

The double-margin geometry stabilises the drill through the full 5× depth, reducing wander and vibration when the flutes are fully engaged. Solid carbide construction maintains edge integrity at higher speeds, while the through-coolant capability — standard on this series — evacuates chips continuously to prevent packing and heat buildup during long, uninterrupted cuts.

Deciding specification

The 14.70 mm diameter is the single figure that determines fit; the tool will not work for holes sized above or below this value. Buyers who need a different diameter, a shorter 3× length, or a replaceable-tip system should select another part number.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $360.99
Pricier than about 91% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

How much heat does the 14.70 mm drill generate during continuous drilling?

The solid carbide construction and double-margin design help dissipate heat evenly along the cutting edges, reducing localised temperature spikes during extended 5×D drilling cycles.

What tool holder or machine is required to run the CXDSR 1470AP?

A rigid CNC machining centre or high-precision drill press with a 14.70 mm capacity collet or hydraulic chuck is needed; hand-held drills cannot maintain the alignment this geometry demands.

Will this 5×D drill work reliably in a older manual mill with standard run-out?

The double-margin layout improves guidance, but excessive spindle run-out on legacy machines can still cause premature margin wear and hole-quality loss at full 5×D depth.

More in Bits, Hole Saws & Accessory Kits

Similar items