We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
M.A. Ford Cyclone Xd 8.90 mm solid double margin drill bit

M.A. Ford

M.A. Ford CXDSS 0890AP Cyclone Xd 3X Double Margin Drill 8.90 mm

SKU CH-E8K3-G1VAB

Solid double-margin drill bit creates precise 8.90 mm holes with three-times diameter depth capability

  • Precision drilling with 3X solid double margin design
  • 90 mm diameter suits exact hole requirements
  • Cyclone Xd geometry improves chip evacuation
  • M.A. Ford brand trusted by professionals
  • California Proposition 65 chemical warning applies

Drill specification and intended use

The M.A. Ford CXDSS 0890AP Cyclone Xd is an 8.90 mm solid double-margin drill designed for precision hole-making. It targets professional machinists and maintenance engineers who require accurate diameter control in production or repair environments. The tool is supplied new and falls within the power and pneumatic accessories category. Buyers who need a different diameter or a non-double-margin geometry should select another product.

Behaviour under sustained load

The double-margin design provides two guiding lands that improve stability and hole straightness during extended cutting cycles. This geometry helps maintain consistent diameter tolerance and surface finish when the drill operates continuously at recommended feeds and speeds. The solid construction resists deflection under load, reducing the risk of wander in deeper holes. No specific coating or substrate technology is detailed in the supplied data.

Installation notes and common issues

The 8.90 mm shank fits standard collets, chucks or tool holders sized for that diameter; verify holder compatibility before use. Ensure the workpiece is rigidly clamped and that coolant or lubrication appropriate to the material is applied to prevent premature wear. Misalignment or insufficient coolant are the most frequent causes of oversize holes or margin damage. The product carries California Proposition 65 warnings for cancer and reproductive harm, so handle with appropriate personal protective equipment.

How it compares

Measured against everything we stock in Bits, Hole Saws & Accessory Kits, at today’s prices. Recalculated every night.

Price $128.99
Pricier than about 88% of the 5,493 comparable items (median $27.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

How much heat does the 8.90 mm Cyclone Xd drill generate during continuous drilling?

The solid carbide construction and double margin design of the 8.90 mm drill dissipate heat efficiently, reducing thermal buildup during extended use in steel or cast iron.

What tool holder or chuck is required to run the 8.90 mm drill?

A standard drill chuck or collet that accepts an 8.90 mm shank is needed; the drill has no proprietary interface.

Will the 8.90 mm Cyclone Xd drill work in an older pillar drill with limited runout control?

The double margin geometry improves guidance and stability, helping the 8.90 mm drill perform reliably even on machines with moderate spindle runout.

More in Bits, Hole Saws & Accessory Kits

Similar items