M.A. Ford Cyclone Xd 5X Solid Double Margin Drill 9.30mm

9.30 mm Solid Carbide Drill

The M.A. Ford Cyclone Xd 5X is a solid carbide drill with a 9.30 mm cutting diameter and a 5× diameter flute length. Its double-margin design improves hole straightness and surface finish in a single pass. The tool suits CNC and manual drilling in steel, cast iron and non-ferrous alloys.

For high-precision production holes

Machinists who need consistent diameter tolerance and reduced wandering will benefit from the double-margin geometry. Shops without rigid spindle run-out control or without through-coolant capability may not achieve the full accuracy this drill can deliver.

Behaviour in extended drilling cycles

The solid carbide body and double margins dissipate heat evenly during sustained cuts, helping the drill hold size over long runs. Continuous operation without peck cycles is possible in favourable materials, though chip evacuation still depends on workpiece setup and coolant pressure.