We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver cylindrical drill bit with double flutes and coolant hole 11.30mm

M.A. Ford

M.A. Ford Cyclone Xd 8X Coolant Fed Double Margin Drill 11.30mm

SKU CH-R80T-QKRVY

Coolant-fed double-margin drill with 11.30 mm diameter for deep, precise holes

  • Coolant-fed design delivers lubrication directly to the cutting zone
  • Double margin construction improves hole straightness and surface finish
  • 8X diameter capability enables deep-hole drilling in one pass
  • 30 mm diameter suits precise metric hole requirements
  • New condition ensures full factory performance and tool life

Cyclone Xd 8X coolant drill

The M.A. Ford Cyclone Xd is an 8X diameter coolant-fed double-margin drill built for deep-hole drilling in production environments. Its 11.30 mm cutting diameter targets manufacturers and machine shops that need consistent hole quality at extended lengths.

Double-margin design for stability

The double-margin geometry provides four-point land contact to improve hole straightness and surface finish while reducing vibration. Through-coolant delivery flushes chips from the flute space, which supports unattended cycling and protects the cutting edges during long runs.

Proposition 65 notice included

The supplier flags that this product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Shops should review their handling procedures and safety-data sheets before putting the tool into service.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $415.99
Pricier than about 91% of the 2,412 comparable items (median $81.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What shank standard does the CXDCLM1130AP use and what maximum drill depth does the 8X designation allow?

The drill uses a straight cylindrical shank; the 8X rating means it can drill up to eight times its 11.30 mm diameter in a single pass.

What machine spindle and coolant system are required to run this 11.30 mm double-margin drill?

A rigid CNC or machining-centre spindle with through-spindle coolant delivery and sufficient torque for an 11.30 mm carbide drill.

How is the coolant-fed drill installed and what common setup error should be avoided?

Clamp the shank in a precision hydraulic or shrink-fit holder, align the coolant ports, and verify run-out; the frequent mistake is using a worn collet that lets the drill walk.

More in Power Drills, Drivers & Cutting Bits

Similar items