We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver twist drill bit with two coolant holes and double margin flutes

M.A. Ford

M.A. Ford Cyclone XD 8X Coolant Fed Double Margin Drill 7.50 mm

SKU CH-4QKY-R7VC8

Coolant-fed double-margin drill creates precise 7.50 mm holes eight diameters deep

  • 8x diameter drilling depth for deep holes
  • Coolant-fed design improves chip evacuation
  • Double margin construction enhances hole accuracy
  • 50 mm cutting diameter for precise sizing
  • M.A. Ford brand trusted in industrial tooling

What the drill is and who it is for

The M.A. Ford Cyclone XD is a 7.50 mm coolant-fed double margin drill built for production drilling where straightness and hole finish matter. It suits CNC operators and tool-room engineers who need an 8× diameter reach without peck cycles. Buyers who need a larger diameter or a non-coolant design will not find those options in this listing.

Thermals noise and power draw

Coolant delivered through the tool flushes chips and controls temperature at the cutting edges during deep-hole work. The double margin design stabilises the drill, reducing vibration that can increase spindle load and audible noise. Power consumption follows the machine spindle and feed rate rather than the drill itself.

What the bundled accessories

No accessories, software or coatings are listed in the supplier data for this part number. The drill ships as a single cutting tool ready for holder mounting. Any performance change comes from the machine coolant system and cutting parameters chosen by the operator.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $210.99
Pricier than about 80% of the 2,412 comparable items (median $81.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

How do I install the 7.50 mm Cyclone XD drill with its coolant-fed shank?

Clamp the shank in a precision collet or hydraulic holder, run true within the holder's rated tolerance, and verify the coolant ports align with the machine's through-spindle supply.

What maintenance or replacement will the double-margin drill need later?

Inspect both margins for wear after each job; resharpen on a CNC grinder when corner breakdown reaches the margin width, and replace once the 7.50 mm diameter falls below tolerance.

What limit appears first under sustained high-feed drilling?

Margin land temperature rises until coolant breakthrough fails, so monitor spindle load and chip evacuation; back off feed before the double-margin design loses its guiding stability.

More in Power Drills, Drivers & Cutting Bits

Similar items