We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver twist drill bit with two coolant holes and double margin flutes, 8.50 mm diameter

M.A. Ford

M.A. Ford Cyclone XD 8X Coolant-Fed Double Margin Drill 8.50 mm

SKU CH-2M81-QWCZA

Coolant-fed double-margin drill with 8X diameter depth capability for 8.50 mm holes

  • 8X drilling depth reaches deep holes efficiently
  • Coolant-fed design clears chips and reduces heat
  • Double margin construction improves hole accuracy and finish
  • 50 mm diameter suits precise metric applications
  • New condition ensures full factory performance and life

What this drill does

The M.A. Ford Cyclone XD is an 8.50 mm coolant-fed double-margin drill built for deep-hole drilling in tough materials. Its 8X diameter design and internal coolant channels deliver consistent chip evacuation and tool life in production environments.

Who it suits and who it does not

Machinists needing a single, long-reach drill for steel, stainless or high-temp alloys will benefit from the double-margin stability. Shops without through-spindle coolant capability or those drilling only shallow holes should consider a standard twist drill instead.

The specification that decides fit

The 8.50 mm cutting diameter and 8X length-to-diameter ratio set the hole size and maximum depth this tool can reach. Verify your machine can supply coolant at the required pressure before ordering.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $240.99
Pricier than about 84% of the 2,412 comparable items (median $81.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What shank size does the 8.50 mm Cyclone XD drill need to fit my holder?

The drill has an 8.50 mm diameter shank, so it requires a holder or collet that accepts an 8.50 mm round shank.

How do I install the coolant-fed drill correctly?

Secure the drill in a compatible holder, connect the coolant supply to the tool's through-spindle port, and verify flow before starting the spindle.

When should I replace the double-margin drill?

Replace the drill when the cutting margins show visible wear, chipping, or when hole quality and dimensional tolerance fall outside acceptable limits.

More in Power Drills, Drivers & Cutting Bits

Similar items