We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 14mm diameter 3-flute twist drill bit 22955120

M.A. Ford

M.A. Ford Twister Al 5X 3 Flute Drill 14.00mm 22955120

SKU CH-C6W4-92MRA

Three-flute 14.00 mm drill for aluminium delivers five-times-diameter reach

  • Designed for aluminium with a three-flute geometry
  • 00 mm cutting diameter for precise hole sizing
  • 5× length-to-diameter ratio for deeper drilling
  • M.A. Ford manufacturing quality for reliable performance
  • California Proposition 65 warning applies to this product

14.00 mm aluminium drill

The M.A. Ford Twister Al 5X is a three-flute drill designed for aluminium and similar non-ferrous materials. Its 14.00 mm diameter suits holes for structural fasteners and pipework in fabrication shops. The 5X length provides extended reach for deep-hole applications without changing tools. It is aimed at machinists who need consistent chip evacuation in soft alloys.

Capacity and headroom

The three-flute geometry balances material removal rate with hole finish in aluminium up to moderate thicknesses. Chip packing becomes the limiting factor once depth approaches the full flute length, especially in gummy tempers. Coolant pressure and peck cycles extend practical depth, but the tool is not intended for high-volume steel drilling.

Interface limits

The drill uses a standard cylindrical shank that fits common three-jaw chucks and collet holders. Run-out at the chuck junction governs hole straightness more than the drill itself at 5X diameter. Prop 65 warnings apply to the coating chemistry, so handling procedures should follow shop safety rules. No through-coolant channel is present.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $223.99
Pricier than about 82% of the 2,412 comparable items (median $81.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

Will the 14.00mm diameter fit the same collets I use with older twist drills?

The 14.00mm shank matches standard metric collets, so it will seat in the same holders you already use for 14mm twist drills.

How can I verify the 3-flute Twister Al 5X is cutting correctly once installed?

Look for a steady three-lobed chip pattern and a smooth hole wall at the 5×D depth — those are the signs the drill is tracking true.

Does the 22955120 package include any coolant adapters or just the drill body?

Only the drill body is supplied; coolant fittings, tool holders and collets must be sourced separately.

More in Power Drills, Drivers & Cutting Bits

Similar items