We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
M.A. Ford Twister Al 5X 3 flute drill bit, silver metal finish

M.A. Ford

M.A. Ford Twister Al 5X 3 Flute Drill 22923400

SKU CH-AMY3-S6KSS

Three-flute drill designed for aluminium with five-times diameter reach

  • Three-flute design improves chip evacuation for aluminium
  • Twister Al 5X geometry extends tool life in non-ferrous metals
  • M.A. Ford precision grinding delivers consistent hole quality
  • California Prop 65 warning informs safe handling practices
  • New condition guarantees full factory performance from first use

Twister Al 5X 3 Flute Drill

The M.A. Ford Twister Al 5X is a three-flute drill designed for aluminium and similar non-ferrous materials. It suits machinists and fabricators who need reliable chip evacuation in soft alloys.

Capacity and headroom with 5X reach

The 5X diameter reach provides deeper drilling capability in a single pass. Three flutes balance material removal and stability, though the tool is not intended for hardened steels or high-temperature alloys.

Upgrading from standard two-flute drills

Shops moving from conventional two-flute drills gain smoother finishes and better hole straightness in aluminium. The step is worthwhile when cycle time and surface quality matter more than tool cost.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $67.99
Cheaper than about 55% of the 2,412 comparable items (median $81.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

Will the 22923400 drill fit the chuck on my older drill press?

The 22923400 uses a standard shank design compatible with common three-jaw chucks found on older drill presses, allowing direct installation without adapters.

How can I verify the Twister Al 5X is cutting correctly after setup?

Check for consistent chip formation and a smooth hole wall; the three-flute geometry should produce even chips and minimal vibration when feed and speed are set for aluminium.

Does the 22923400 package include cutting fluid or a storage case?

The box contains only the 22923400 drill bit; cutting fluid and a protective case must be purchased separately.

More in Power Drills, Drivers & Cutting Bits

Similar items