We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver twist drill bit with three flutes and tapered point

M.A. Ford

M.A. Ford Twister Al 5X 3 Flute Drill 33/64 22951560

SKU CH-7AA4-N07N2

Drills precise 33/64-inch holes in aluminium with five-times-diameter reach and three-flute chip evacuation

  • Designed for aluminium with three-flute geometry
  • 5x diameter reach for deeper holes
  • 33/64 inch cutting diameter for precise sizing
  • M.A. Ford quality for reliable performance
  • California Prop 65 chemical warning applies

33/64 Twister Al 5X 3 Flute Drill

The M.A. Ford 22951560 is a solid-carbide drill with a 33/64 inch diameter and three flutes. It belongs to the Twister Al 5X series designed for aluminium and other non-ferrous materials. The tool is supplied new and ships directly from the manufacturer.

Machinists cutting aluminium or soft alloys

This drill suits workshops that need a dedicated 33/64 inch carbide tool for high-speed non-ferrous work. Shops that primarily drill steel, titanium or hardened alloys should select a geometry made for those materials.

Standard shank fits common holders

The straight shank installs in any compatible collet or drill chuck without adapters. Running the tool above recommended speeds for aluminium can cause built-up edge and premature wear, so verify parameters before cutting.

How it compares

Measured against everything we stock in Power Drills, Drivers & Cutting Bits, at today’s prices. Recalculated every night.

Price $234.99
Pricier than about 83% of the 2,412 comparable items (median $81.99).

Specifications

Product
Brand nameM.A. FORD

Questions about this item

What size drill chuck is required to hold the 33/64 inch shank?

A chuck that opens to at least 33/64 inch is needed to grip the shank of the Twister Al 5X 22951560 drill bit.

Can this 3-flute drill be used in a standard handheld drill motor?

Yes, the 33/64 inch diameter shank fits common 1/2 inch capacity drill chucks found on many handheld drill motors.

How can I confirm the drill is cutting correctly after setup?

The three flutes should produce consistent, curled chips and the hole diameter should measure close to 33/64 inch when the drill is running true.

More in Power Drills, Drivers & Cutting Bits

Similar items