M.A. Ford Twister Gp 3X Drill 13.00Mm pneumatic accessory

13.00 mm Twister Gp 3X Drill

The M.A. Ford Twister Gp 3X Drill is a 13.00 mm pneumatic accessory built for power-tool users who need a single cutting diameter. It is supplied new under manufacturer part number 22651180 and carries the brand’s standard construction. The drill suits workshops that run compressed-air systems and want a dedicated size for repetitive hole-making tasks.

Compatibility check before ordering

Verify that your pneumatic tool accepts a 13.00 mm shank and that your air supply delivers the pressure and flow the drill requires. Confirm the chuck or collet type matches the accessory so it seats securely without adapters. California Proposition 65 notices apply because the product contains chemicals known to cause cancer and birth defects or other reproductive harm.

Sustained-load behaviour

Under continuous operation the drill maintains its cutting geometry while the air motor runs at steady pressure. Heat builds gradually in the cutting zone rather than spiking in short bursts, so the tool relies on the compressed-air stream and workpiece material to carry heat away. Chip evacuation stays consistent as long as the air supply remains stable.