Manfrotto 3093 Cable Clamps 32-45mm 4-Pack

Cable clamps for 32-45 mm cables

The Manfrotto 3093 clamps secure cables with diameters from 32 mm to 45 mm (1.1 to 1.57 inches). Each pack contains four lightweight plastic clamps weighing 0.03 kg in total. They are built for studio and location work where tidy cable runs prevent trips and protect gear. The adjustable grip suits a range of power and data cables used in lighting and camera rigs.

Replaces loose tape or ties

These clamps upgrade from single-use tape, hook-and-loop straps or zip ties that must be cut off for every change. The jump is worth it when you reroute cables daily on stands or truss and need a reusable, non-marring hold that survives repeated setup and teardown. They are not for permanent conduit installs or cables thinner than 32 mm that would slip in the jaws.

Clamps onto poles and stands

Installation is a simple squeeze onto a pole, stand leg or truss chord; the built-in locking tab snaps shut to hold the cable bundle. What usually goes wrong is over-tightening on the smallest cables, which can deform the plastic jaw, or mounting on oversized tubing where the clamp cannot close fully. No tools are required.