Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Ready-to-install 160 W Ushio UHP bulb in housing rated for 2,000 normal or 5,000 economy hours
The Mitsubishi HC4900 replacement lamp module arrives as a fully assembled 160W Ushio UHP bulb inside its housing, so no separate bulb handling is required during installation. It is built for owners of the HC4900 projector who need a direct-fit replacement that restores original brightness without alignment steps.
Each unit undergoes testing for beam performance, ignition reliability, voltage stability, connector integrity and run-time consistency before it ships. The pre-assembled housing ensures the lamp seats securely in the projector’s lamp compartment, reducing the risk of misalignment that can cause premature failure or uneven illumination.
In standard mode the lamp delivers approximately 2000 hours of operation, while the projector’s economy setting extends usable life to around 5000 hours. Buyers who need longer intervals between replacements should note that no higher-wattage or extended-life variant is offered for this model.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 (Normal) - 5,000 (Economy) Hrs. |
| Power | |
| Power rating | 160 W |
The module is built as a direct replacement for Mitsubishi HC4900 projectors and includes the housing so it seats correctly in the lamp compartment.
The housing matches the original HC4900 form factor and uses the projector's existing lamp-door screws and alignment tabs; no extra brackets or adapters are needed.
After inserting the module, the lamp-hour counter in the projector menu must be reset to zero; otherwise the projector will still show the old hours and may shut down early.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?