ModMyMods USB 3.0 20-Pin Header MF Extension Low Profile 120mm

Low-Profile USB 3.0 Header Extension

This 120 mm cable extends a 20-pin internal USB 3.0 header from the motherboard to a more accessible position. The low-profile male-to-female design suits tight builds where a standard straight connector would foul adjacent components or panel cut-outs. It is intended for system builders who need to route the front-panel USB 3.0 connection without altering the board layout.

90-Degree Connector Build Quality

The angled 19/20-pin connector sits close to the PCB, reducing vertical clearance requirements inside compact chassis. Black insulation and a short 12 cm run keep cable clutter to a minimum while preserving signal integrity for USB 3.0 data rates. The miniature form factor allows the header to sit flush against the motherboard edge, leaving room for large coolers or graphics cards mounted directly above.

Compatibility Check Before Ordering

Verify that your motherboard provides a 20-pin internal USB 3.0 header with the standard 19/20-pin keying before purchase. Ensure the 120 mm length reaches from the header to your chosen front-panel or bracket location without tension. This cable does not convert between header types or add additional ports, so it will not suit builds needing a header splitter or a different pin count.