Corsair RM750e CP-9020295-NA 750 W power supply
- Black
- ATX 3.1 Compatible
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A 30 cm PSU cable extension kit with 24-pin motherboard, two CPU and three GPU connectors in red sleeved 18AWG wiring
This 30 cm extension kit adds a 24-pin motherboard cable, two 4+4-pin CPU cables and three 6+2-pin GPU cables to an existing power supply. The 18AWG UL 1015 tinned copper conductors and high-density braided sleeves give a professional look while staying routable inside the case. Cable combs are included for clean alignment. Builders who want a single-colour accent without replacing the PSU itself will find the kit convenient.
The set suits anyone extending a standard ATX power supply in a custom loop or air-cooled build where the stock cables fall short of the motherboard and graphics card. It does not help builders who need longer runs than 30 cm, who require a different colour than red, or who want pre-curved cables ready to install without training. Systems using non-standard PSU pin-outs or proprietary connectors are also outside the kit's scope.
The 300 mm length is the single figure that decides fit; measure from your PSU to the 24-pin, CPU and GPU headers before ordering. If the distance exceeds 30 cm the extensions will not reach, and no other length is included in this package.
Measured against everything we stock in ATX Desktop Power Supplies, at today’s prices. Recalculated every night.
New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product type | AT |
Connect each 30 cm extension between the PSU and the component, then use the supplied cable combs to align the 18 AWG wires; the step many miss is training the braid into smooth curves before final tightening.
Inspect the braided sleeves and combs annually for abrasion or loose clips; replace any cable that shows conductor exposure or melted insulation, otherwise the kit is rated for continuous use.
The 18 AWG conductors set the practical ceiling; sustained draws near their ampacity will raise sleeve temperature first, so keep total load within the wire gauge rating.
More in ATX Desktop Power Supplies
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?