NavePoint Cat6 Keystone Jack 90° Type 110 White 25-Pack

NavePoint Cat6 90° Keystone Jacks 25-Pack

This pack contains twenty-five white Cat6 keystone jacks designed for structured cabling. The 90-degree right-angle orientation eases termination in tight wall plates or patch panels. Gold-plated RJ45 contacts and fire-retardant thermoplastic construction meet TIA/EIA 568-C.2 Category 6 performance requirements. Suitable for installers and network builders terminating solid 23 or 24 AWG conductors.

Verify cabling and tooling before ordering

Confirm that the installation uses solid 23 or 24 AWG cable compatible with 110-type IDC terminations. The colour-coded modules support both T568A and T568B wiring schemes, so check the project standard. A 110 or Krone impact tool is required for seating conductors, and the snap-in retaining clip must match the keystone blank dimensions in the panel or wall plate. Dust caps are included for strain relief.

Thermals noise and power in normal use

As passive copper components, these jacks draw no power and generate no audible noise or measurable heat during operation. The high-temperature thermoplastic housing maintains structural integrity under typical indoor environmental conditions. Gold-plated contacts resist oxidation to preserve signal integrity over the link lifetime. No active cooling or power budgeting is required for the jacks themselves.