NEMIX RAM 16GB DDR5 4800 CL40 1.1V 288-Pin UDIMM for Kingston KVR48U40BS8-16 memory upgrade

16GB DDR5 UDIMM for Kingston systems

This 16GB DDR5 module runs at 4800MHz with CL40 latency and 1.10V operation. It uses a 288-pin unbuffered non-ECC design built for desktop motherboards that accept Kingston KVR48U40BS8-16 memory. The single-rank 1Rx8 configuration fits standard DDR5 slots. Builders upgrading compatible Kingston platforms can install it directly.

Unbuffered non-ECC build with major OEM chips

The stick uses Samsung, Micron or Hynix components without a heat spreader, keeping the profile low for tight slots. As an unbuffered non-ECC UDIMM it plugs straight into consumer desktop boards that support DDR5 4800. No registration or error correction circuitry means simpler signal paths for standard workloads. The 1.10V voltage matches the DDR5 baseline.

CL40 latency at DDR5 4800 decides fit

The critical spec is CAS latency 40 at 4800MT/s, which determines whether your motherboard and CPU memory controller will run the module at its rated speed without manual tuning. Systems requiring lower latency or higher data rates will not reach their targets with this part. Buyers needing ECC, registered buffering or speeds above 4800MT/s should look elsewhere.