NEMIX RAM 256GB 4x64GB DDR5 5600 ECC Registered RDIMM memory upgrade for Supermicro X14SRA-T

256GB DDR5 5600 ECC RDIMM kit

This 256GB kit contains four 64GB DDR5 5600 registered ECC RDIMMs built for the Supermicro X14SRA-T motherboard. Each module runs at 1.1V with CL46 latency and a 2Rx4 rank layout that matches the board's memory controller expectations. The registered design allows full population of all slots at rated speed without signal degradation. It is intended for servers and workstations that require maximum capacity with error correction.

DDR5 5600 registered ECC limits

DDR5 5600 (PC5-44800) sets the maximum transfer rate this kit can deliver on a compatible platform. Registered DIMMs add a clock cycle of buffering, which stabilises heavy loads but prevents use in systems that only accept unbuffered UDIMMs. ECC corrects single-bit errors automatically, yet it cannot repair multi-bit failures or replace a proper backup strategy. The 288-pin form factor fits only DDR5 RDIMM slots and is mechanically incompatible with other generations.

Check your Supermicro X14SRA-T configuration

Before ordering, verify the motherboard manual for approved DIMM population order, maximum supported capacity per slot, and any BIOS version requirements for 64GB modules. Confirm the server chassis provides enough clearance for four full-height RDIMMs and that the power budget covers the additional memory draw. Systems limited to lower densities or unbuffered memory will not recognise this kit.