NEMIX RAM 96GB (6×16GB) DDR5 5600 CL46 1Rx8 ECC RDIMM Supermicro H13DSG-O-CPU memory upgrade

Exact-match DDR5 RDIMM kit

This 96GB kit contains six 16GB DDR5-5600 registered ECC modules built to the precise rank, voltage and timing the Supermicro H13DSG-O-CPU memory controller expects. Each 288-pin RDIMM runs at 1.10V with CL46 latency and 1Rx8 organisation so the board recognises full capacity at rated speed. The registered architecture offloads the controller allowing every slot to be populated while ECC corrects single-bit errors on the fly.

Verify DIMM population rules

Server and motherboard memory support varies by model so consult your system or motherboard manual for supported capacities approved DIMM population order and installation steps before purchase. The board requires 288-pin registered RDIMMs not UDIMMs or SODIMMs and this kit matches that form factor exactly. Confirm the maximum memory per channel and total slots available to ensure the six-module configuration is supported.

Replaces partial or slower DDR5 configurations

Upgrading from a partially populated setup or lower-speed DDR5 modules lets the memory controller run all channels at the full 5600 MT/s rate with ECC protection active. The jump is worth it when workloads need the full 96GB capacity at spec speed and registered buffering for stability under sustained load. Buyers who need a different capacity or a UDIMM form factor should look elsewhere.