We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red over-ear headphones with padded cushions and adjustable headband, coiled cable with 3.5mm and 6.35mm plugs

OneOdio Pro-10 Over-Ear Headphones 50mm Drivers 32 ohm 3.5mm 6.35mm Jack Red

SKU CH-7JSF-BXQKM MPN Pro-10

Wired over-ear headphones with 50 mm drivers, 32 ohm impedance, and detachable 3.5 mm and 6.35 mm jacks for studio monitoring and DJ use

  • Frequency range5 Hz-16 kHz
  • Impedance80 ohms
  • Connection3.5 mm
  • Wearing styleEarbud
  • Noise cancellationPassive
  • Mic signal-to-noise ratio110 decibels
  • 50 mm neodymium drivers deliver deep bass for mixing and monitoring
  • Detachable 3.5 mm and 6.35 mm plugs remove the need for an adapter
  • 90 ° swivelling ear cups enable single-side monitoring during sessions
  • Adjustable headband with soft padded cushions provides comfort for extended use
  • 8 ft cable gives freedom of movement around equipment

Studio DJ headphones with dual jacks

The OneOdio Pro-10 is a wired over-ear headphone built for studio monitoring, DJ mixing, recording and podcasting. Large 50 mm neodymium drivers deliver dynamic bass response. The 32 ohm impedance suits portable devices and professional gear alike. Red finish distinguishes this model in a busy booth.

Detachable cables and swivel cups

Two detachable cables terminate in 3.5 mm and 6.35 mm plugs so no adapter is needed. The 9.8-foot cord reaches across a control room. Ear cups swivel 90° for single-ear monitoring. Padded cushions and an adjustable headband aim for fatigue-free sessions. Passive isolation blocks ambient noise.

Check your source jack and impedance match

Verify that your mixer, interface, laptop or instrument provides a 3.5 mm or 6.35 mm output. The 32 ohm load is easy to drive but confirm your gear can supply adequate voltage for the desired volume. No microphone is included; a separate mic is required for voice work.

How it compares

Measured against everything we stock in Earbuds & Over-Ear Headphones, at today’s prices. Recalculated every night.

Price $56.99
Pricier than about 74% of the 7,078 comparable items (median $25.99).

Specifications

Product
Brand namePHILIPS
Product lineClassic Series
Model nameWFL900/H
Part numberPro-red
Product typeOn-Ear
Product colorWhite
Audio & video
Frequency range5 Hz-16 kHz
Impedance80 ohms
Wearing styleEarbud
Noise cancellationPassive
Mic signal-to-noise ratio110 decibels
Mic sensitivity110 decibels
Ports & slots
Connection3.5 mm
Power
Power supplyNo
Compatibility
Compatible withUniversal
Supported platformsCertified for Windows Vista
In the box
In the boxHeadphone, Ear Cushions, Cable

Questions about this item

How can I confirm the 50 mm neodymium drivers are producing the advertised 5 Hz – 16 kHz frequency response after setup?

Play a frequency-sweep test tone from 5 Hz to 16 kHz through the 3.5 mm or 6.35 mm plug and listen for even output across the range; the 32 ohm impedance and 110 dB microphone SNR figures indicate the drivers are performing to spec.

What comes in the box and which cables or adapters must I purchase separately?

The package includes the headphones, ear cushions and a detachable 9.8-foot cable with both 3.5 mm and 6.35 mm plugs; no extra adapters are required for devices with either jack size.

Should I choose the 32 ohm or 80 ohm version for studio monitoring with a 6.35 mm interface?

The Pro-10 is a 32 ohm model optimised for universal 3.5 mm and 6.35 mm jacks; the 80 ohm figure belongs to a different Philips reference and is not an option for this headphone.

More in Earbuds & Over-Ear Headphones

Similar items