We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Onsrud 37-01 carbide engraving tool 60 degree tip 0.005 inch

Onsrud

Onsrud 37-01 engraving tool carbide 0.005 in 60 deg hand tool

SKU CH-0SXW-5SHKW

Carbide engraving tool with a 60-degree tip and 0.005 inch width for precise marking

  • Product typeHole, Drill, Bore & Wire Gauges
  • Carbide construction resists wear for longer tool life
  • 60-degree tip angle produces clean V-groove cuts
  • 005-inch tip width enables fine detail engraving
  • Uncoated carbide suits a variety of workpiece materials
  • Single-piece design simplifies setup in hand-held use

Precision Engraving Tip 0.005 in

The Onsrud 37-01 is a carbide engraving tool ground to a 0.005 inch tip with a 60 degree included angle. It is supplied new and uncoached for clean cuts in a variety of materials. This hand tool suits detail work where a fine point is required.

Replaces Worn Fine-Point Cutters

The tool replaces an engraving tip that has dulled or chipped at the 0.005 inch size. The jump is worth it when the previous cutter no longer holds a sharp edge at this diameter. A 30 degree variant exists for different groove profiles.

Simple Collet Swap

Installation consists of placing the shank into a compatible collet or holder and tightening securely. What usually goes wrong is running the tool without confirming the holder runs true, which snaps the fine carbide point immediately.

How it compares

Measured against everything we stock in Utility & Specialty Hand Tools, at today’s prices. Recalculated every night.

Price $29.99
Pricier than about 59% of the 2,474 comparable items (median $23.99).

Specifications

Product
Brand nameOnsrud
Product typeHole, Drill, Bore & Wire Gauges

Questions about this item

What shank diameter fits the Onsrud 37-01 engraving tool?

The tool has a 1/2 in. shank that fits standard 1/2 in. collets or holders used on CNC routers and engraving spindles.

How is the 30 degree carbide tip installed, and what step is often missed?

Insert the tool into the collet until the shank seats fully, then tighten the collet nut to the machine maker's torque spec; the step often missed is verifying the tip runs true with a dial indicator before cutting.

When will the 0.005 in. tip need replacement?

Replace the tip when the 0.005 in. point shows visible wear, chipping, or when engraving quality drops, typically after extended use in abrasive materials.

More in Utility & Specialty Hand Tools

Similar items