OPTOMA EzPro 771 Projector Lamp 200W 2000 Hrs

Direct Replacement Lamp Module

The Optoma EzPro 771 lamp module ships as a complete assembly with a 200W P-VIP bulb already seated in its housing. It is designed for owners of the EzPro 771 projector who need a new light source without sourcing a bare bulb and cage separately. The unit arrives ready to install, matching the form factor of the original module supplied with the projector. Buyers who require a different wattage or a bare bulb for a custom housing cannot use this module.

2000 Hour Rated Life

The lamp carries a 2000 hour rated lifespan under standard operating conditions. Actual runtime will vary with projector usage patterns, ventilation, and how often the unit is power-cycled. Frequent short sessions and dusty environments tend to reduce the practical hours achieved before brightness drops below usable levels. The 200W power draw is fixed by the projector's ballast and cannot be adjusted to extend life.

Tool-Less Housing Swap

Installation consists of removing the projector's lamp door, sliding out the old module, and inserting the new one until it seats firmly. No tools are required beyond a screwdriver for the door screw on most models. The most common issue is failing to reset the lamp hour counter in the projector menu after replacement, which leaves the warning message active. Another frequent oversight is not cleaning the air filters at the same time, leading to premature overheating of the new lamp.