OPTOMA NOBO S15E projector lamp 200W 2000 Hrs
200 W replacement lamp module with 2 000-hour rated life for Optoma projectors
- Power rating200 W
- Lamp lifespan2,000 Hrs.
- Product typeProjector Lamp
- Ready to install with pre-assembled bulb and housing
- Bright 200W Phoenix NSH lamp powers your Optoma projector
- Rated 2000 hours of projection time before replacement
- Manufactured to ISO9001 quality standards for reliable performance
- Compatible replacement for Optoma model SP.80V01.001
Ready-to-install lamp module
The OPTOMA NOBO S15E is a complete projector lamp assembly that combines a new 200W Phoenix NSH bulb with its housing. It arrives fully assembled for direct replacement in compatible Optoma projectors without additional handling.
Suited for standard-cycle replacements
This module targets users who need a straightforward 2,000-hour lamp swap for routine maintenance. It is not intended for buyers who require extended-life lamps rated for significantly longer run-times or higher-wattage alternatives.
Fits existing projector housing
The unit slots into the projector’s original lamp compartment using the factory mounting points and power connector. No extra brackets, cables or tools are needed, leaving the surrounding optics and cooling layout unchanged.
How it compares
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
- Price $125.99
- Pricier than about 71% of the 9,513 comparable items (median $99.99).
- Power rating 200 W
- Lower than about 60% of the 8,831 comparable items (median 215 W).
Specifications
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 Hrs. |
| Power | |
| Power rating | 200 W |
Questions about this item
Which Optoma projectors accept the SP.80V01.001 lamp module?
The SP.80V01.001 module fits Optoma projectors that specify the NOBO S15E lamp; check your projector's manual or original lamp label for that exact part number before ordering.
Will the 200 W Phoenix NSH bulb match the brightness and ignition timing of the original lamp?
The replacement uses a genuine 200 W Phoenix NSH bulb built to ISO 9001 quality checks for beam performance, ignition, voltage and run-time, so it reproduces the original output.
How can I confirm the new lamp is operating correctly after installation?
Reset the projector's lamp-hour counter, then verify the on-screen timer starts from zero and the image reaches full brightness without flicker or error messages.
More in Replacement Projector Bulbs
Similar items
Toshiba TDP-T30 projector lamp 180W UHP 2000 3000 hrs
- 180 W
- 2,000 (Normal) - 3,…
Toshiba TDP-SW25 180W UHP projector lamp
- 180 W
- 2,000 (Normal) - 3,…





