We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green 240-pin DDR3 ECC registered RDIMM module, no heat spreader

OWC

OWC 16GB DDR3 1333 PC3-10600 CL9 2Rx4 240-pin 1.5V ECC Registered RDIMM for Dell PowerEdge R920 T410 T610 T710

SKU CH-DWGF-PBEZA

Adds 16 GB of DDR3 ECC registered memory at 1333 MHz for Dell PowerEdge R920, T410, T610 and T710 servers

  • Total capacity16 GB
  • Rated speedDDR3 1333 (PC3 10600)
  • CAS latencyCL9
  • Rated voltage1.5 V
  • Buffer typeRegistered
  • Memory rank2Rx4

Capacity 16GB

  • 16 GB capacity expands server memory headroom
  • DDR3 1333 MHz CL9 matches Dell PowerEdge specifications
  • ECC registered design protects data integrity in workloads
  • 240-pin 1.5 V RDIMM fits R920 T410 T610 T710 slots
  • Single 16 GB module simplifies upgrade installation

Server memory upgrade

This 16GB DDR3 ECC registered DIMM is built for Dell PowerEdge R920, T410, T610 and T710 servers. It runs at 1333MHz with CL9 latency and 1.5V operation. The module uses a 2Rx4 rank configuration on a 240-pin interface. It is not compatible with standard desktop computers or unbuffered memory.

Thermals and power

The module operates at the standard 1.5V DDR3 voltage without a heat spreader. Registered buffering reduces electrical load on the memory controller during sustained workloads. ECC circuitry adds minimal overhead while correcting single-bit errors. Power draw stays within JEDEC limits for PC3-10600 modules.

Build and installation

The bare green PCB fits directly into 240-pin DDR3 slots on the listed PowerEdge models. Registered signalling requires a compatible server chipset to function. Mixing with unbuffered DIMMs will prevent boot. The single-module design allows incremental capacity increases up to the system maximum.

How it compares

Measured against everything we stock in Model-Specific Memory Upgrades, at today’s prices. Recalculated every night.

Price $43.99
Cheaper than about 79% of the 21,161 comparable items (median $397.99).
Total capacity 16 GB
Lower than about 70% of the 20,941 comparable items (median 32 GB).
Price per GB $2.75 per GB
Cheaper than about 91% of the 20,941 comparable items (median $8.19 per GB).

New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.

Specifications

Product
Brand nameOWC
Part number1R3D32R416 GB
Total capacity16 GB
Product type240-Pin DDR3 ECC RDIMM
Performance
Rated speedDDR3 1333 (PC3 10600)
Memory
CAS latencyCL9
ECC supportYes
Buffer typeRegistered
Memory rank2Rx4
Heat spreaderNo
Power
Rated voltage1.5 V
Compatibility
Compatible systemsDell PowerEdge R920
Dell PowerEdge T410
Dell PowerEdge T610
Dell PowerEdge T710

Other versions of this model

5 more in the same range

Questions about this item

How do I install this 240-pin DDR3 ECC Registered RDIMM in a Dell PowerEdge T610, and what step is often missed?

Power off the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both latches click, then verify in BIOS that the 16GB module is recognised at 1333MHz. The step often missed is confirming the memory mode supports registered DIMMs and not mixing with unbuffered modules.

What maintenance or replacement will this 16GB DDR3 1333MHz CL9 module need over its service life?

No scheduled maintenance is required for the module itself. Keep server air filters clean so the 1.5V DIMM stays within thermal limits. Replacement is only needed if a memory error persists after reseating, or when total capacity must exceed the slot limit of the R920, T410, T610 or T710 platform.

What limit appears first when this 2Rx4 1.5V registered DIMM runs sustained workloads on a PowerEdge R920?

The memory controller’s maximum supported frequency of 1333MHz (PC3-10600) is the first ceiling; the module will not run faster. Beyond that, the 2Rx4 organisation and registered buffer add slight latency, so sustained bandwidth is capped by the DDR3 1333 interface rather than the 16GB capacity or 1.5V supply.

More in Model-Specific Memory Upgrades

Similar items