OWC 8GB DDR3 1600 CL11 2Rx8 1.5V Non-ECC DIMM for OptiPlex 9020

OWC 8GB DDR3 1600 DIMM for OptiPlex 9020

This 8GB DDR3 1600 CL11 module is built for Dell OptiPlex 9020 Micro, SFF, Tower and USFF desktops. It uses a 240-pin unbuffered non-ECC design at 1.5V. The single DIMM adds memory capacity to supported systems without requiring configuration changes. Buyers who need ECC protection or registered modules cannot use this product.

JEDEC-standard DDR3 1600 sustained operation

The module meets JEDEC PC3-12800 specifications and runs at the rated 1600 speed with CL11 latency under continuous load. 2Rx8 organisation allows the memory controller to interleave accesses across ranks, helping maintain throughput during extended multitasking sessions. No heat spreader is fitted, so airflow in the chassis determines thermal headroom. Builders who want overclocking headroom or lower latency timings cannot achieve them with this specification.

Tool-free DIMM installation in OptiPlex chassis

Installation follows the standard 240-pin DIMM procedure: align the notch, press until the retention clips engage, then verify detection in BIOS. The OptiPlex 9020 Micro and USFF layouts place slots in tight spaces, so fingers may need to reach past drive cages or power cables. Systems that already populate every slot with mismatched ranks or speeds may fail to post until the configuration is uniform. Buyers who lack physical access to the motherboard or cannot open the chassis cannot complete the upgrade.