OWC 8GB DDR4 2666MHz CL19 1.2V 288-Pin UDIMM for Dell Inspiron 3470 3471 3670 3671
- 8 GB
- DDR4 2666
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
An 8 GB DDR4 SODIMM running at 2400 MHz with CL17 timing, built for NCR POS CX7 (7772) and CX8 (7736) systems
This OWC module is an 8GB DDR4 2400 SODIMM built specifically for the NCR POS CX7 All-in-One POS (7772) and CX8 POS (7736). It provides a direct memory upgrade for those point-of-sale systems. The 260-pin form factor matches the slots in these units.
The module runs at the standard DDR4 voltage of 1.2V and is unbuffered non-ECC with a CL17 latency. It carries no heat spreader, relying on the system's existing airflow. JEDEC and ROHS compliance ensures the upgrade is warranty-safe for the supported hardware.
This kit consists of one 8GB stick organised as 1Rx8, rated for DDR4 2400 (PC4-19200). It adds exactly eight gigabytes of capacity; systems requiring a matched pair or a larger total capacity will need additional modules.
Measured against everything we stock in Model-Specific Memory Upgrades, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | OWC |
| Part number | 2S4D41R808 GB |
| Total capacity | 8 GB |
| Product type | 260-Pin DDR4 Non-ECC SODIMM |
| Performance | |
| Rated speed | DDR4 2400 (PC4 19200) |
| Memory | |
| CAS latency | CL17 |
| ECC support | No |
| Buffer type | Unbuffered |
| Memory rank | 1Rx8 |
| Heat spreader | No |
| Power | |
| Rated voltage | 1.2 V |
| Compatibility | |
| Compatible systems | NCR POS CX7 All-in-One POS (7772) NCR POS CX8 POS (7736) |
Other versions of this model
Power off the terminal, unplug it, open the memory access panel, align the notch on the module with the slot key, press firmly until both side clips click shut, then verify the new 8GB appears in BIOS before closing the case.
No scheduled maintenance is required; the module has no heat spreader and no moving parts, so replacement is only necessary if a memory test reports errors or the system fails to recognise the 8GB capacity.
The CAS latency of 17 cycles at 2400 MT/s sets the baseline access delay; under continuous load the memory controller will hit that timing wall before bandwidth or voltage headroom becomes a bottleneck.
More in Model-Specific Memory Upgrades
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?