Canon 5322B001 projector lamp 245 Watt for LV-7490 LV-8320
- 245 W
- 3,000 (Normal) - 5,…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement 300 W UHM dual-lamp module rated for 2 000 normal or 3 000 economy hours, ready to install
The ET-LAD7700W is a 300W UHM dual-lamp module built as a direct replacement for the Panasonic PT-DW7000 projector. It arrives as a fully assembled bulb and housing so the unit can be swapped without extra tools or alignment steps. The lamp is manufactured to ISO9001 standards and tested for beam performance, ignition, voltage and run-time before it leaves the factory.
Because the bulb comes pre-mounted in its housing, installation is a single-step process that does not require handling the bare lamp or adjusting the reflector. The dual-lamp design means both light sources are replaced together, keeping brightness and colour balance consistent across the image. The module connects to the projector using the existing connector, so no wiring changes are needed.
In normal operation the lamp is rated for 2,000 hours and up to 3,000 hours when the projector runs in economy mode. The package includes the lamp module only; no additional cables, filters or software are supplied. Buyers who need a different wattage or a single-lamp configuration should look for the module that matches their specific projector model.
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 2,000 (Normal) - 3,000 (Economy) Hrs. |
| Power | |
| Power rating | 300 W |
The ET-LAD7700W is a direct-fit lamp module for the PT-DW7000 projector; the 300W UHM dual-lamp design restores the projector's rated brightness without a separate ballast upgrade.
The module ships as a complete bulb-and-housing assembly sized for the PT-DW7000 lamp cage, so no extra brackets or adapters are needed.
Power off and cool the projector, open the lamp door, release the securing screws, swap the entire module, re-tighten the screws, close the door, then reset the lamp-hour counter in the menu — the reset is the step most often forgotten.
More in Replacement Projector Bulbs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?