Link Depot Corp. USB-DB25 6 ft USB to DB25 printer cable
- USB To DB 25
- Black
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Extends a 2-pin I/O power connection by 60 cm with a sleeved black cable
This Phobya cable extends a 2-pin I/O power connection by 60 centimetres. It is intended for system builders and modders who need to reposition a front-panel header or similar low-voltage device inside a chassis. The sleeved black finish keeps the installation tidy. The part is identified by supplier number 82395.
The 60-centimetre length comfortably reaches from a motherboard header to a front-panel board in most mid-tower and full-tower cases. It runs out when the routing path requires sharp bends or exceeds the cable’s reach in extended-height enclosures. The two-pin connector carries only the signal and ground lines for simple switching functions. No additional conductors are present for power delivery.
The single specification that decides fitment is the 2-pin I/O connector type. It matches headers labelled for power switches, reset switches or similar momentary contacts. Builders needing a 3-pin fan header, a 4-pin PWM header or a USB internal connector cannot use this cable. Verify the motherboard or controller pin-out before purchasing.
Measured against everything we stock in USB & Parallel Printer Cables, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Product color | Black |
The cable carries a standard 2-pin I/O signal, so it connects the front-panel power switch to the motherboard header on any ATX board that uses a two-pin power connector.
Press the case power button; the system should start immediately. If it does not, check that both ends of the 60cm cable are fully pushed onto the 2-pin headers.
The package contains only the one 60cm black sleeved 2-pin I/O extension cable; no additional connectors, combs or tools are supplied.
More in USB & Parallel Printer Cables
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?