We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Plato ETR chisel soldering tip 1.6 mm wide silver metal cylinder 34.5 mm long

Plato

Plato ETR Soldering Tip 1.6 mm Chisel Weller PES51

SKU CH-EKNH-K0DK7

A 1.6 mm chisel soldering tip compatible with Weller PES50, PES51, WES50, WES51 and WD1 stations

  • Product typeETR
  • Chisel tip suits precise joint work
  • 6 mm width fits fine-pitch components
  • 5 mm length reaches tight spaces
  • 7 mm thickness improves heat transfer
  • Works with Weller PES51 and WD1 stations

Plato ETR 1.6 mm Chisel Tip

This Plato ETR chisel tip measures 1.6 mm wide and 34.5 mm long with a 6.8 mm outside diameter and 0.7 mm thickness. It fits Weller EC1201A, EC1204A, PES50 and PES51 handpieces and works with WD1, WD2, WE1010 and WES series stations up to 850 degrees F.

Replaces Worn ETR Chisel Tips

Swap this tip in when the existing ETR chisel on a compatible Weller iron shows erosion, poor wetting or physical damage that affects joint quality. The upgrade is worth it when the old tip no longer holds solder cleanly or the chisel edge has deformed beyond reliable re-tinning.

Check Handpiece And Station Compatibility

Verify that your handpiece is one of the listed EC1201A, EC1204A, PES50 or PES51 models and that your station is a WD1, WD2, WE1010, WES50, WES51 or WESD51PU unit. The tip will not fit other Weller series or non-Weller handpieces.

How it compares

Measured against everything we stock in Soldering Irons & Stations, at today’s prices. Recalculated every night.

Price $7.99
Cheaper than about 92% of the 802 comparable items (median $25.99).

Specifications

Product
Brand namePlato
Product typeETR

Questions about this item

What handpiece diameter does the 6.8 mm tip outside diameter fit?

The tip slides directly onto Weller handpieces such as the EC1201A, EC1204A, PES50, PES51 and WCC101 models without an adapter.

How do I install the chisel tip on a Weller PES51 handpiece, and what step is often missed?

Push the tip fully onto the heater barrel until it seats against the internal shoulder; the common mistake is leaving a gap that causes poor thermal transfer.

When should I replace the 0.7 mm thick chisel tip?

Replace it when the plating wears through, the chisel edge becomes pitted or the tip no longer wets cleanly at normal operating temperature.

More in Soldering Irons & Stations

Similar items