Pomona Electronics 2249-C-24 BNC Coaxial Cable 24 in
BNC male-to-male coaxial cable, 24 in, 50 ohm, DC to 4 GHz, 500 Vrms, 20 AWG, PE insulation, nickel-plated brass, -104 °F to 185 °F
- Product typeElectronic
- Reliable signal integrity up to 4 GHz bandwidth
- Durable nickel-plated brass connectors resist corrosion
- Flexible 24 in length suits bench setups
- 50 ohm impedance matches standard test equipment
- Operates from -104 °F to 185 °F environments
BNC test cable for DC to 4 GHz signals
The Pomona Electronics 2249-C-24 is a 24 in BNC male-to-male coaxial cable built for bench and field measurements. Its 50 ohm impedance and nickel-plated brass connectors suit RF engineers, technicians and hobbyists who need a reliable path from DC up to 4 GHz.
20 AWG centre conductor with 500 Vrms rating
The 20 AWG wire and polyethylene insulation handle continuous signals up to 500 Vrms across the full DC to 4 GHz range. Attenuation rises with frequency, so very long runs or ultra-low-loss applications will exceed the practical headroom of this short jumper.
Nickel-plated brass connectors and 90-day warranty
The nickel-plated brass BNC plugs resist corrosion and maintain stable contact resistance through repeated mating cycles. A 90-day manufacturer warranty covers defects in materials and workmanship for the cable assembly.
How it compares
Measured against everything we stock in Meters, Testers & Measuring Tools, at today’s prices. Recalculated every night.
- Price $20.99
- Cheaper than about 76% of the 3,030 comparable items (median $54.99).
Specifications
| Product | |
|---|---|
| Brand name | POMONA |
| Product type | Electronic |
Questions about this item
Will the 50 ohm BNC connectors on this 2249-C-24 cable match the 50 ohm ports on my older oscilloscope?
Yes, the cable presents a 50 ohm impedance and uses BNC male plugs that fit standard 50 ohm BNC jacks on legacy scopes and generators.
How can I verify the 24 inch assembly is passing signals up to 4 GHz without a network analyser?
Connect a known good source and load, then check for clean rise time and expected amplitude on your scope; a distorted edge suggests a damaged centre conductor or shield.
Does the box include any adapters or terminators, or just the nickel-plated brass BNC male-to-male cable?
Only the 24 inch coaxial cable with BNC male connectors on each end is supplied; 50 ohm terminators, T-pieces or N-type adapters must be purchased separately.
More in Meters, Testers & Measuring Tools
Similar items
Jansicotek KW310 OBD2 measurement tool 1996+
- Energy Star Qualifi…
- 5.94 × 3.22 × 2.2 in
Test Probes 4 Pack 2mm 600V/10A 0.2mm Needle 8.6cm Reach 3.7cm Grip
- Test Leads





