Unique-Bargains BNC Male to 3.5mm Mono TS Male Coaxial Cable 1.22m 50 ohm
- HI - Antennas, Wire…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A dual-polarity Yagi MIMO antenna covering 4.9–5.8 GHz with 17 dBi gain and two N-Female connectors for WiFi 5 and WiFi 4 links
This dual-polarity Yagi antenna covers the 4.9-5.8 GHz band with 17 dBi gain and is made for MIMO point-to-multipoint links. It fits WiFi 5 and WiFi 4 networks as well as public-safety channels in the 4900-5850 MHz range. Installers who need a single antenna with two N-Female ports for spatial diversity will find it a direct fit.
The 17 dBi figure holds across the full 4900-5850 MHz span, so throughput stays consistent whether the link sits at the low or high end. Dual polarity keeps both spatial streams active under sustained load, reducing the drop-outs that single-polarity designs show when fading deepens. No internal amplifiers mean the noise floor does not rise during long transmissions.
The stainless-steel mount kit bolts to a mast and lets you tilt and swivel the antenna without extra tools, so peak signal is found quickly. Two integral N-Female jacks sit at the feed point; cable routing is straightforward but the connectors are fixed, so pigtail length must be planned before the antenna is raised. No grounding lug is included, so a separate earth strap is needed for lightning protection.
Measured against everything we stock in Antennas, Cables & Rigging Fittings, at today’s prices. Recalculated every night.
| Product | |
|---|---|
| Product type | Antenna |
The antenna is a passive device with no active electronics, so it produces no measurable heat while running all day.
You will need two N-Male terminated coaxial cables and a router or radio with two N-Female ports to use both polarities for MIMO.
Yes, it supports IEEE 802.11n (WiFi 4) and 802.11a across the full 4900-5850 MHz range, so legacy equipment can connect.
More in Antennas, Cables & Rigging Fittings
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?