RGB LED Strip Extension Cable 5m 16.4ft 4-pin 5050 3528 2835 Black 2-pack

Extension Cable for 10 mm RGB Strips

This 5 m 4-pin extension cable connects 10 mm wide 5050, 3528 or 2835 RGB LED strips to a controller or to each other. Two cables and four male-to-male plugs are supplied in the pack, letting you bridge gaps without soldering. The black PVC jacket is rated for indoor use and the stranded copper conductors tolerate repeated flexing. Each cable measures 16.4 ft end to end.

Check Strip Width and Pin Layout

Verify that your LED strips are exactly 10 mm wide and use a standard 4-pin RGB pin-out before ordering. The pre-soldered female connectors only fit that specific strip width and pin spacing. Confirm your controller also presents a matching 4-pin header so the male plugs seat correctly. No other strip widths or connector types are compatible with the supplied hardware.

Solderless Plugs Enable Quick Reconfiguration

Four male-to-male plugs are included so you can join two strips directly or adapt a cut strip end without a soldering iron. The plug-and-play design lets you reposition or extend runs in minutes rather than hours. Because the connectors are reusable, you can rearrange lighting layouts whenever the installation changes. The pack contains no controller, power supply or adhesive tape.