Crucial CT2K8G3S160BM 16GB (2 x 8GB) DDR3 1600 SO-DIMM memory upgrade
- 16 GB (2 × 8 GB)
- DDR3 1600
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
ECC registered DDR4 RDIMM for servers with 8 GB capacity, 2133 MHz speed, CL15 latency and 1.2 V operation
This 8 GB DDR4 registered module runs at 2133 MT/s with CL15 latency and 1.2 V operation. It uses a 1Rx4 organisation and 288-pin form factor for server and workstation platforms that require ECC protection. The part is validated for system-specific compatibility and is not intended for desktop or laptop PCs.
Standard DDR4 voltage of 1.2 V keeps power consumption low for dense server configurations. Registered buffering reduces electrical load on the memory controller, helping maintain signal integrity across populated channels. No active cooling is required on the module itself under normal airflow conditions.
This module replaces a failed or missing stick in qualified server boards that demand registered ECC memory at 2133 speed. The jump is worth it when expanding capacity within the same speed grade or when a platform specifically lists this part number as supported. It does not suit consumer desktop or laptop upgrades.
Measured against everything we stock in Model-Specific Memory Upgrades, at today’s prices. Recalculated every night.
New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | SAMSUNG |
| Model name | Samsung M393A1G40EB1-CPB |
| Total capacity | 8 GB |
| Product type | 288-Pin DDR4 SDRAM |
| Performance | |
| Rated speed | DDR4 2133 (PC4 17000) |
| Memory | |
| CAS latency | CL15 |
| ECC support | Yes |
| Buffer type | Registered |
| Memory rank | 1Rx4 |
| Power | |
| Rated voltage | 1.2 V |
| Compatibility | |
| Compatible systems | For Server, Not For PC |
Align the notch with the slot key, press firmly until both latches click, and verify the module is fully seated — partial insertion is the common error that prevents POST.
No routine maintenance is required; if errors appear, run a memory diagnostic and replace the individual stick if it fails, since ECC corrects single-bit faults but cannot repair a defective chip.
The registered buffer adds one cycle of latency, so sustained throughput is capped by the 2133 MT/s data rate and CL15 timing rather than thermal or voltage headroom.
More in Model-Specific Memory Upgrades
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?