Seagate IronWolf Pro 4TB 7200 RPM 256MB CMR SATA 3.5" internal hard drive ST4000NE001
- 4 TB
- SATA 6.0Gb/s
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
8TB 7200 RPM CMR SATA drive with 256MB cache, AgileArray dual-plane balancing and RV sensors for multi-bay NAS reliability
Capacity 8TB
The Seagate IronWolf Pro ST8000NE001 is an 8 TB hard drive built for 24×7 operation in network-attached storage. It uses conventional magnetic recording and a 7200 RPM spindle to deliver consistent throughput for RAID arrays. The SATA 6.0Gb/s interface fits standard 3.5 inch drive bays in NAS appliances and servers. AgileArray firmware adds dual-plane balancing and time-limited error recovery for multi-bay stability.
Rotational vibration sensors allow the drive to maintain performance when installed alongside other drives in the same chassis. AgileArray power management reduces consumption during idle periods while keeping the drive ready for workload bursts. The 256 MB cache absorbs write spikes to smooth latency. Average latency is 4.16 ms under typical access patterns.
The drive is rated for up to 300 TB of data written or read each year, a figure that determines whether it matches the intended NAS workload. A 2.5 million hour MTBF rating and three-year Rescue Data Recovery service support long-term deployment. Buyers who need a higher annualised workload figure should consider drives with a larger rating.
Measured against everything we stock in 3.5-Inch Internal Desktop HDDs, at today’s prices. Recalculated every night.
New to this? Paying with USDT: TRC-20 or ERC-20 — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | Seagate |
| Product line | IronWolf Pro |
| Model name | ST8000NE001 |
| Total capacity | 8 TB |
| Recommended use | Enterprise NAS Hard Drives |
| Performance | |
| Rotational speed | 7,200 RPM |
| Mean latency | 4.16 ms |
| Storage | |
| Cache memory | 256 MB |
| Ports & slots | |
| Interface type | SATA 6.0Gb/s |
| Size & build | |
| Form factor | 3.5 in (8.89 cm) |
| Max height | 26.11 mm |
| Maximum width | 101.85 mm |
| Maximum length | 146.99 mm |
| Shipping weight | 0.72 kg |
| Package size | 171 × 138 × 37 mm |
Other versions of this model
Mount the 3.5" drive in a bay, connect the SATA 6.0Gb/s data and power cables, then enable AgileArray dual-plane balancing and rotational vibration sensor support in the NAS firmware so the 7200 RPM spindle stays stable in multi-drive arrays.
The drive is rated for a 300TB yearly workload and 2.5M hours MTBF; plan to replace it once cumulative writes approach the workload limit or if IronWolf Health Management reports declining SMART attributes.
The 300TB per year workload rating is the primary ceiling; sustained writes beyond that level can accelerate wear before the 2.5M hour MTBF target is reached.
More in 3.5-Inch Internal Desktop HDDs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?