Sharp XV-Z18000 projector lamp 250W Phoenix SHP
A 250W Phoenix SHP bulb in a ready-to-install housing rated for 3,000 hours
- Power rating250 W
- Lamp lifespan3,000 Hrs.
- Product typeProjector Lamp
- Ready-to-install module with housing included
- 250 W Phoenix SHP bulb delivers rated output
- 3,000-hour lamp life supports extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Sharp XV-Z18000 projector
Sharp XV-Z18000 projector lamp 250W
This replacement lamp module is built for the Sharp XV-Z18000 projector and ships as a complete 250 W bulb inside its housing. Home-cinema owners and small-venue installers can swap it in without handling a bare burner.
Direct OEM replacement for the original ANK15LP
It takes the place of the factory lamp that shipped with the projector and restores rated brightness when the original reaches its 3 000-hour service limit. The upgrade is worthwhile once image dimming or a lamp-warning message appears during regular use.
Pre-assembled housing enables tool-free installation
The unit slides into the projector's lamp compartment and locks with the existing latch; no separate bulb alignment is required. The most common issue is forgetting to reset the projector's hour counter after fitting the new module.
How it compares
Measured against everything we stock in Replacement Projector Bulbs, at today’s prices. Recalculated every night.
- Price $150.99
- Pricier than about 82% of the 9,513 comparable items (median $99.99).
- Power rating 250 W
- Higher than about 70% of the 8,831 comparable items (median 215 W).
Specifications
| Product | |
|---|---|
| Brand name | Sharp |
| Product type | Projector Lamp |
| Display | |
| Lamp lifespan | 3,000 Hrs. |
| Power | |
| Power rating | 250 W |
Questions about this item
Which Sharp projector models accept the ANK15LP lamp module?
The ANK15LP module is built for the Sharp XV-Z18000 projector and fits the original lamp compartment without adapters.
What is the correct way to seat the lamp housing so the projector recognises it?
Slide the housing straight in until the connector clicks, then tighten the two captive screws; skipping the screw step leaves the safety switch open and the projector will not strike the lamp.
When should I plan to replace the Phoenix SHP 250W bulb inside this module?
The lamp is rated for 3000 hours of typical use; the projector’s hour counter will warn you when the limit is approached.
More in Replacement Projector Bulbs
Similar items
3M Dukane DPS-3 OEM Philips UHB Projector Lamp 165W 2000 Hrs
- 165 W
- 2,000 Hrs.
Sanyo PDT-DHT100WL Projector Lamp 330W NSHA POA-LMP130
- 330 W
- 2,000 (Normal) - 3,…





