Simmtec, Inc 4GB DDR3 1333 MT/s CL9 SODIMM 204-Pin 1.35V/1.5V memory upgrade

4 GB DDR3 SODIMM 1333 MT/s CL9

This is a single 4 GB DDR3 SODIMM module rated at 1333 MT/s with CL9 latency. It uses the standard 204-pin layout and supports dual-voltage operation at 1.35 V or 1.5 V. The module is unbuffered and non-ECC. It suits notebook owners who need a direct replacement or capacity increase for a DDR3 SODIMM slot.

Fits DDR3 SODIMM notebooks only

The part works in notebooks that accept DDR3 SODIMM memory at 1333 MT/s or slower with CL9 timing. It will not work in laptops that require ECC or registered memory. Systems limited to a different memory generation or form factor cannot use this module. Buyers should verify their notebook’s memory specification before ordering.

Dual-voltage 1.35 V / 1.5 V operation

The module runs at either 1.35 V or 1.5 V, matching the voltage supplied by the notebook’s memory controller. This flexibility allows it to install in both low-voltage and standard-voltage DDR3 platforms without configuration changes. Confirm the original module’s voltage if the system documentation specifies only one value.