SMUGDESK Mini SAS SFF-8087 to 4 SATA Breakout Cable 1M
Converts a single Mini SAS SFF-8087 port into four SATA connections for 2.5 or 3.5 drives, with a 3.3 ft length for flexible server routing
- Converts one Mini SAS port to four SATA drives
- 1 meter length enables flexible routing in server chassis
- High-speed signal transmission suits RAID controllers and storage servers
- Reinforced molded connectors resist vibration for stable operation
- Supports 2.5 and 3.5 SATA HDD and SSD drives
Server storage expansion
This 1M Mini SAS forward breakout cable converts a single SFF-8087 port into four independent SATA interfaces. It connects RAID controllers and storage servers directly to 2.5 and 3.5 SATA drives. The design suits DIY NAS builds, server upgrades and data centre storage arrays.
Thermals noise and power
Passive copper conductors carry data without active cooling or external power draw. Molded connector shells absorb vibration from chassis fans and drive movement. The 1M length allows routing away from high-airflow zones to reduce cable stress.
Bundled value
No additional accessories or software are included with the cable. The reinforced connectors themselves provide the strain relief that prevents loose contacts during long-term operation. Buyers needing latch-equipped SATA cables or angled connectors must source them separately.
How it compares
Measured against everything we stock in SAS, SCSI, InfiniBand & MCIO Cables, at today’s prices. Recalculated every night.
- Price $13.99
- Cheaper than about 87% of the 1,224 comparable items (median $26.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
How do I plug the SFF-8087 end into my RAID controller without bending the pins?
Align the keyed SFF-8087 male connector with the controller port, press straight in until the latch clicks, and route the 1M cable so the four SATA tails have no sharp bends near the backplane.
Which part of this breakout cable wears out first and needs replacing?
The SATA data connectors see the most insertions; if a drive swap feels loose or shows intermittent errors, replace the whole 1M assembly rather than re-using a stretched latch.
What speed limit appears first when the array runs flat-out for hours?
The SATA 3.5 Gb/s or 6 Gb/s link on each drive caps sustained throughput long before the Mini SAS trunk saturates.
More in SAS, SCSI, InfiniBand & MCIO Cables
Similar items
EN-Labs SFF-8643 to 4×SFF-8482 SAS cable with SATA 15-pin power 1.64ft
- Others
- Black & Blue
Mellanox Technologies MFA1A00-E001 LinkX InfiniBand cable QSFP+ 3.28 ft
10Gtek Mini SAS SFF-8087 cable, 1.64 ft, 2 pack
- Cable Connectors
- Black





