We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three spools of copper desoldering braid, 2.5 mm wide, 9.8 ft each

Soldering 12 2.5mm 9.8ft 3pcs

SKU CH-NGPD-TDXPB

Copper desoldering braid with no-clean flux, 2.5 mm wide by 9.8 ft long, three pieces per pack

  • Fit and compatibilityOut-Opening, Narrow Stile, Store Front Doors
  • Certifications and standardsLead Free Compliant
  • 100 % copper braid conducts heat fast for quick solder removal
  • No-clean flux leaves minimal non-conductive residue after desoldering
  • Fine braid design creates strong capillary action to pull excess solder
  • 5 mm width suits small PCB components and tight joints
  • Three 9.8 ft rolls provide ample length for multiple rework tasks

Copper desoldering braid for PCB repair

This 2.5 mm wide copper braid uses flat stitch weaving to create strong capillary action that pulls excess solder from small PCB boards. The 100 % copper construction conducts heat quickly so the wick draws solder away without damaging pads or components. Three pieces at 9.8 ft each supply enough length for repeated rework sessions in labs, workshops or home benches.

Simple placement with flux core

Lay the braid over the joint, apply the iron tip and the no-clean flux activates instantly to start wicking solder into the copper strands. Residue left behind is non-conductive and non-corrosive so boards do not require extra cleaning steps. The narrow 0.10 in width fits tight component spacing but cannot reach underneath large connectors or dense BGA packages where access is blocked.

Steady performance during long desoldering runs

Copper mass absorbs heat continuously so the braid remains effective across multiple joints without saturating as quickly as thinner wicks. Flux activity stays consistent through the full 9.8 ft roll, preventing dry spots that can stall solder uptake. For very high-volume production lines the single 2.5 mm size may require frequent roll changes compared to bulk dispenser formats.

How it compares

Measured against everything we stock in Soldering Irons & Stations, at today’s prices. Recalculated every night.

Price $15.99
Cheaper than about 70% of the 802 comparable items (median $25.99).

Specifications

Compatibility
Fit and compatibilityOut-Opening, Narrow Stile, Store Front Doors
Environment & compliance
Certifications and standardsLead Free Compliant

Questions about this item

How can I confirm the solder wick is removing solder effectively after I apply it to a joint?

The copper braid will draw molten solder into its strands through capillary action, leaving the pad clean with only a small amount of non-conductive, non-corrosive residue that requires no further cleaning.

What items are included in the package and is any additional flux required for use?

The pack contains three spools of 2.5 mm wide, 9.8 ft long lead-free desoldering braid with no-clean flux already embedded in the copper; no separate flux purchase is needed.

Which width and length combination should I select for general PCB rework tasks?

The 2.5 mm width and 9.8 ft length per spool suit a broad range of component sizes and provide enough material for multiple desoldering jobs across the three included pieces.

More in Soldering Irons & Stations

Similar items