Soldering Wick Braid 2.0/3.5 mm 2 m

Desoldering Braid 2.0/3.5 mm

This halogen-free, ultra-low-residue copper wick is designed for electronic component repair and PCB rework. The fine braid promotes strong capillary action to pull excess solder from joints quickly. It suits professionals and hobbyists working on mobile phone motherboards, tablets, keyboards and general circuit boards. The 2 m roll provides ample length for multiple desoldering tasks.

Upgrades from basic wick or pump tools

The anti-scalding thumb-wheel dispenser with a stainless steel spout gives controlled feed and heat protection during use. This design improves precision on small, hard-to-reach pads where a simple coil or manual pump is awkward. The jump is worth it when you need low-residue, halogen-free cleanup on dense boards without spreading flux or risking component damage from excessive heat.

Capacity and headroom

The 2.0 mm and 3.5 mm widths handle typical through-hole and surface-mount joints on consumer electronics. The 2 m length covers dozens of component removals such as relays, switches or connectors. It runs out on very large ground planes or high-mass connectors where solder volume exceeds the braid's capillary capacity in a single pass.