Athena Power AP-P4ATX60FE 600W server power supply
- 600 W
- Single
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Replacement power supply for MP502A1-Y02A VH25142 servers, listed October 2023
This new server power supply is built as a direct replacement for the MP502A1-Y02A VH25142 platform. It targets system administrators and integrators maintaining compatible rack equipment. The unit supplies the exact electrical interface that the original chassis expects. No other applications are implied by the available data.
The supply uses the native connector layout defined for the MP502A1-Y02A VH25142, so installation follows the standard server hot-swap procedure. Locking tabs and keying prevent misalignment during rapid change-outs. Construction follows typical server-grade ventilation and enclosure practices. Buyers needing redundant N+1 configurations should verify chassis slot count independently.
This unit replaces a failed or degraded OEM module of the same part number, restoring original power capacity without firmware changes. The jump is worth it when the existing supply shows voltage drift, fan failure or capacity loss under load. It does not add headroom for GPU accelerators or additional drive cages beyond the original specification. Builders expanding beyond the stock configuration need a different power architecture.
Measured against everything we stock in Server & Hot-Plug PSUs, at today’s prices. Recalculated every night.
New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The MP502A1-Y02A VH25142 is a server power supply unit designed to slot into compatible server chassis power bays.
This unit follows a standard redundant PSU form factor and requires a matching hot-swap bay with rear latch access.
Slide the unit firmly into the bay until the latch clicks; the most common error is stopping before the latch engages fully.
More in Server & Hot-Plug PSUs
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?