Tripp Lite PV400USB 400W power inverter 12V 120V 2 USB 2 outlet
- 2 × 5-15R
- 3 ft (0.91 m)
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts 48V DC to split-phase 110V and 220V AC at 60Hz with 5000W continuous and 20000W peak per phase, plus 40000W peak surge, pure sine wave output, built-in UPS, battery charger and LCD display
This low-frequency pure-sine-wave inverter converts 48 V DC into simultaneous 110 V and 220 V AC at 60 Hz, delivering 5000 W continuous per leg with a 10000 W combined rating. It suits off-grid solar installations, backup-power setups and mobile applications that require both North-American and European voltages from a single battery bank.
The unit integrates a 110 V battery charger and automatic UPS transfer so connected loads stay powered during grid loss. An LCD panel reports voltage, current and wattage for each output, while power-save mode reduces idle draw. Terminal blocks accept L1, L2 and neutral for flexible split-phase wiring.
The inverter can supply 20000 W peak on each 110 V or 220 V circuit, reaching 40000 W total instantaneous power to start heavy inductive loads such as compressors or pumps. Continuous output remains limited to 5000 W per voltage, so systems sized only for sustained draw above that level will need additional capacity.
Measured against everything we stock in DC-to-AC Power Inverters, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Brand name | U-POWER |
The unit supplies 5000 W continuous on the 110 V leg, 5000 W continuous on the 220 V leg, or 5000 W combined when both voltages run together.
A 48 V battery bank and cables rated for the full DC current are needed; the inverter draws roughly 200 A at 48 V when delivering 10000 W.
Connect L1, N and L2 — L1+N gives 110 V, L2+N gives the second 110 V, and L1+L2 gives 220 V; the LCD then shows full data for both voltages.
More in DC-to-AC Power Inverters
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?